Prescolite 1375 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite 1375. Prescolite 1375 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
InstructionSheet
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives of
fices in principal cities throughout North
America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .05282500
InstructionSheet
INSTALLATION INSTRUCTIONS
CAT NO. 1371 & 1375
Housing
Pivot
Adjustment
Ring
Trim Retaining Clip (3)
Housing Clip
J-Box
Lamp
(by others)
Adjustment
Screw (2)
Transformer
(277/120 Volt
version only)
Thermal Protector
Adjustable
Bar Hanger
Rotation/Pivot
Yoke
CAUTION: To avoid electrical shock, be sure power supply is turned off before installing or servicing this fixture.
WARNING - RISK OF FIRE:
Do not install insulation within three (3) inches of fixtures sides, wiring compartment or top of fixture
in such a manner to entrap heat.
1. Refer to instruction sheet No. 463 (included) to assemble the bar hangers, install
and adjust the housing.
2. Adjust the fixture so the bottom edge of the plaster flange is flush with the finished
ceiling line. Accomplish this using the adjustable screws securing the mounting
brackets on either end of the fixture.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker.
All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET101 Corporate Drive • Sparta

Page 2

www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET101 Corporate Drive • Spartanburg, SC 29303

Modèles reliés 1371

Commentaires sur ces manuels

Pas de commentaire