Prescolite 6W3ST Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite 6W3ST. Prescolite 6W3ST User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
InstructionSheet
Part No........................................................93008460
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and
instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and
proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during
servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed
by qualified service personnel. Product must be grounded to avoid potential electric shock or other
potential hazard. Product must be mounted in locations and at heights and in a manner consistent with
its intended use, and in compliance with the National Electrical Code and local building codes. The use
of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe
condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow
items such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as
this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
6W3, 6W3ST TRIM
www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET
NOTE: Vertical angle must be positioned at 20 degrees as described below for optics to perform as required.
A. Lamp Adjustment Prior To Trim Installation:
1. Loosen horizontal and vertical locking Thumbscrews as shown, (1) & (2).
2. Remove Lamp Holder (3). Install lamp into Socket (4). Re-install Lamp Holder into Lamp Mounting Plate (5).
3. Turn power on.
4. Install clips (6) x2 by inserting screws (7) x2 through hole in clip and slots (8) x2 of lamp plate using a 1/4” nutdriver to thread
screws into slots. NOTE: Clips must be in correct orientation. Do not overtighten screws.
5. Install Diffuse lens (9) with smooth side facing up towards lamp by placing notches on lens in between clips (6) as shown.
6. Rotate Lamp Plate (5) to 20 degrees vertical angle and lock vertical locking Thumbscrew (2). NOTE: Vertical increment
indicator numbers can be used to set position at 20 degrees.
B. Trim Installation:
1. Remove Screw (10), pull Safety Cable (11) through opening in Plaster Frame and attach to Trim as shown using screw (10).
2. Squeeze the two Torsion Springs (12) together and insert ends into slots on both Brackets (13) as shown.
3. Push Trim towards ceiling until the Torsion Springs force the Trim against the ceiling line.
C. Final Adjustment:
1. Make final horizontal adjustment by holding outer flange on Trim and rotating horizontally. NOTE: If necessary, pull the
flange away from the ceiling slightly before rotating.
2. Push Trim back towards ceiling until seated against ceiling.
D. Locking Vertical and Horizontal Aim:
NOTE: Turn power off and allow lamp to cool if necessary.
1. Pull Trim away from ceiling, reach into housing and rotate two Thumb Screws (1) & (2), clockwise to lock in place.
2. Push Trim back towards ceiling until seated against ceiling.
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY
AND PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2007, 06/07, All Rights Reserved - Printed in U.S.A.
Vue de la page 0
1

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetPart No..............93008460IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY

Modèles reliés 6W3

Commentaires sur ces manuels

Pas de commentaire