Prescolite ALA12 Manuel d'utilisateur télécharger pdf

InstructionSheet

www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives ofﬁces in principal cities throughout North America.

07/9/13

Part No ..................................................... 143640100

Sheet 1 of 2

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and

instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and

proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during

servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed

by qualiﬁed service personnel. Product must be grounded to avoid potential electric shock or other

potential hazard. Product must be mounted in locations and at heights and in a manner consistent with

its intended use, and in compliance with the National Electrical Code and local building codes. The use

of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe

condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow

items such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as

this may cause an unsafe condition.

WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other

reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

INSTRUCTIONS FOR DPRL & DPRVML

1. LOOSEN 2 HEX SCREWS AT BOTTOM OF HEATSINK OF THE FIXTURE HALFWAY.

2. PASS RETAINER THROUGH DIFFUSER AS SHOWN . ALIGN RETAINER MOUNTING

KEYHOLES TO HEATSINK SCREWS, TURN RETAINER CLOCKWISE, AND TIGHTEN

SCREWS.

RETAINER

HEATSINK

8-32 HEX HEAD

SCREWS (2)

(SUPPLIED)

INSTRUCTIONS FOR CLEANING:

USE A DAMP CLOTH FOR CLEANING INSIDE OF DIFFUSER.

INSTRUCTIONS FOR ALA12

NOTE: INSTALL LENS ASSEMBLY (ALA12) AFTER

ASSEMBLING ACRYLIC DIFFUSER ASSEMBLY

(PRESCOLITE CAT. NO. DPRL OR DPRVML)

1. FIT LENS TO DIFFUSER APERTURE AS SHOWN AND

STRETCH BAND/SPRING ASSEMBLY OVER DIFFUSER RIM

AND LENS RIM.

2. ALA12 IS NOT TO BE USED ON DPRG.

SEE PAGE 2 FOR FIGURE OF FULLY INSTALLED FIXTURE.

BAND/SPRING

ASSEMBLY

(INSTALL ONLY IF

ALA12 IS PROVIDED)

LENS (INSTALL

ONLY IF ALA12 IS

PROVIDED)

DIFFUSER/GLASS

REFRACTOR

INSTALLATION INSTRUCTIONS

DPRL, DPRVML, ALA12

1 2

InstructionSheet 1

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET 701 Millennium Blvd, Gree

Page 2

InstructionSheetwww.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET 701 Millennium Blvd, Gree

Modèles reliés DPRVML | DPRL |

Commentaires sur ces manuels

Pas de commentaire

Prescolite ALA12 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite ALA12. Prescolite ALA12 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés DPRVML | DPRL |

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Prescolite ALA12