Prescolite ST812 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite ST812. Prescolite ST812 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
InstructionSheet
www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06269400
InstructionSheet
INSTALLATION INSTRUCTIONS
ST612/ST812 SERIES REFLECTOR
1.
Install Lamps (NOTE: SEE
RELAMP
LABEL
INSIDE FIXTURE FOR MAXIMUM
WATTAGE).
2. Aim Housing by rotating housing such that lamp faces wall to be illuminated (as
shown in Fig. 1).
3. Trim Installation:
a) Verify alignment of notch in lens with retainer spring (See Fig. 1).
b) Check orientation of trim with lamp (See Fig. 1, lens to be facing wall to be
illuminated).
c) Squeeze torsion spring legs together and place them into torsion spring
brackets (See Fig. 2).
d) Push trim up and allow the torsion springs to pull the trim up against the ceiling.
4.
T
o remove trim for relamping:
Push lens up into fixture, grab cone edge with fingertips and pull the trim down
(Note: lens retaining spring will limit the upward movement of the lens. See Fig. 3).
PAR-38 LAMP
OR
R-40 LAMP
TRIM
ASSEMBLY
REFLECTOR
PL SERIES
FLOURESENT
LAMP
W
ALL TO BE
ILLUMINATED
SAVE THESE INSTRUCTIONS
LENS
NOTCH
FIG. 1
CEILING
TORSION
SPRING
(1 OF 2)
LENS
RETAINER
SPRING
TORSION
SPRING
BRACKET
(1 OF 2)
TRIM
ASSEMBLY
FIG. 2
LENS
RETAINER
SPRING
TRIM
ASSEMBLY
INSTALLED
FIG. 3
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
701 Millennium Boulevard • Greenville, SC 29607
With representatives of
fices in principal cities throughout North
America.
Copyright 2007, 02/07 revision, All Rights Reserved - Printed in U.S.A.
Vue de la page 0
1

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ETPart No. . . . . . . . . . . . . . . .

Modèles reliés ST612

Commentaires sur ces manuels

Pas de commentaire