InstructionSheet
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives of
fices in principal cities throughout North
America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06287200
InstructionSheet
INSTALLATION INSTRUCTIONS
CFT6/832H EB/EBDM
REFLECTOR
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER
OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
INSTALL REFLECTOR WITH WING
NUT
INSTALL FIXTURE BY BENDING
OUT BRACKETS FOR BAR
HANGERS OR CHANNEL
WHEN USING WALL WASH REFLECTORS,
KICKER GOES AWAY FROM WALL
1.
Bend brackets as shown. Install
the fixture in the ceiling using
mounting channel or bar (by
others) placed in the adjustable
mounting brackets. Mount the
fixture in the ceiling so that the
weight of the fixture is
supported by the mounting
channel or bar and/or hanger
wires secured to the building
structure.
2. Adjust the fixture so the bottom
of the plaster flange is flush with
the finished ceiling line and in
alignment with adjacent fixtures.
Secure mounting brackets by
tightening wing nuts on either
side of the fixture.
3. Remove J-Box cover plate.
Remove appropriate knockout
and assemble appropriate
connector for the supply wire
used. Connect ground wires to
green ground leads. Connect
white (common) to white (leads).
Connect power supply (line) to
black lead(s). Connect ballast
and socket leads using quick-
connect plugs. Reinstall J-Box
cover.
W
ARNING: DO NOT pinch
wires between J-Box/ballast
cover and J-Box. Consult a
Qualified Electrician for all
other options that require
other wiring configurations.
4.
Install reflector after all ceiling
installation and finishing work is
complete.
5. Push reflector into plaster flange.
Next tighten reflector to ceiling
with wing nut.
6. Install the proper lamps (by
others).
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels