Prescolite S-4 STRAP WALL OR CEILING MOUNT Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite S-4 STRAP WALL OR CEILING MOUNT. Prescolite S-4 STRAP WALL OR CEILING MOUNT User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
InstructionSheet
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives of
fices in principal cities throughout North
America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .01857200
InstructionSheet
INSTALLATION INSTRUCTIONS
WALL OR CEILING MOUNT—#S-4 STRAP
Tools Required: Screwdriver (Note: A right angle screwdriver may be
helpful in mounting some models)
O-Ring
1. Insert two #8-32 screws in strap thru tapped holes located on inner slot pattern (2
3
/
4
" dia.).
Holes in canopy must line up with these screws.
2. Use screws in O.B. to mount strap with inserted screw stems (Step 1) facing outward.
Rotate strap to adjust fixture to correct position.
3. Secure fixturecanopy with two mounting nuts.
4. Fixtures located in wet locations must utilize the two o-rings. Place the o-rings under the
heads of the mounting screws and secure fixture to mounting strap.
3
1
/
4
" or 4" O.B.
#8-32 Screw
S-4 Strap
Outlet Box Mounting Screws
Fixture Canopy
O-Ring (See note 4)
Mounting Nuts
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
Vue de la page 0
1

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET101 Corporate Drive • Sparta

Commentaires sur ces manuels

Pas de commentaire