InstructionSheet
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2011, 11/3/11 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93039272
InstructionSheet
INSTALLATION INSTRUCTIONS
RECESSED AISLE LIGHT 93047LED
1. Install the conduit (by others) to align with tapped hole to be used in the housing.
2. Remove faceplate
3. To install housing for concrete pour, fasten mounting brackets to reinforcing steel
or other structure. For drywall construction, frame in the housing as required. The
housing should be flush with the finished wall surface for both wet and drywall
construction (Fig 2).
4. Remove the ballast cover plate and the J-Box cover plate.
5. Remove appropriate knockout and assemble appropriate connector for the supply
wire used. Connect ground wires to green ground leads. Connect white (common)
to white (leads). Connect power supply (line) to the driver leads. Reinstall J-Box
cover.
WARNING:
1. DO NOT pinch wires between J-Box/ballast cover and J-Box.
Consult a Qualified Electrician for all other options that require
other wiring configurations.
Replace the ballast cover plate.
6. Reassemble the faceplate.
Figure 1
Housing
Figure 2
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and
instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and
proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during
servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential
hazard. Product must be mounted in locations and at heights and in a manner consistent with its intended
use, and in compliance with the National Electrical Code and local codes. The use of accessory equipment not
recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light
emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains,
screens or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION: If through branch circuit conductors are
pulled through the junction box, please use extreme
caution so as not to damage or disconnect thermal
protection wiring. Do not modify or defeat the
thermal protection circuit designed into the fixture.
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels