Prescolite CF13P185EB Manuel d'utilisateur télécharger pdf

InstructionSheet

www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET

101 Corporate Drive• Spartanburg, SC 29303

With representatives of

fices in principal cities throughout North

America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93001022

InstructionSheet

INSTALLATION INSTRUCTIONS

CF13P157EB / CF13P170EB /

CF13P185EB

1. Secure pendant mount assembly to 3 1/2" or 4"

octagonal box. End slots and casting are provided

for additional security, and additional bolts through

these slots are reccommended for application

where winds, vibration or earthquake may be

encountered. Make electrical connections.

2. Rest canopy on top of the luminaire and then feed

pendant assembly leads into luminaire. Engage

pendant thread and rotate luminaire a few times.

Make sure leads are hanging freely. Rotate

luminaire until pendant threads are fully engaged.

Connect the wires. Tighten thread clamp screw to

block luminaire to pendant.

3. If luminaire is not hanging straight, loosen the four

ball clamp screws in pendant casting. Align

luminaire and tighten screws.

4. Install canopy.

5. Feed channel assembly leads into luminaire.

Engage running thread and rotate the luminaire a

few times. Make sure plug is hanging freely

Rotate luminaire until canopy contacts ceiling.

ighten thread clamp screw to lock luminaire to

running thread.

6. If installed in windy areas, or in areas subject to

vibration or earthquakes, a safety chain or cable is

recommended (by others).

Clamp Ball

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information

and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,

and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and

during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by

qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.

Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in

compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by

the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from

product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or

the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.

Ball

Housing Swival

Ball

Cover Housing

Swival

Stem

Housing

Reflector

ing Nut (2)

InstructionSheet 1

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET101 Corporate Drive• Spartan

Modèles reliés CF13P170EB | CF13P157EB |

Commentaires sur ces manuels

Pas de commentaire

Prescolite CF13P185EB Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite CF13P185EB. Prescolite CF13P185EB User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés CF13P170EB | CF13P157EB |

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Prescolite CF13P185EB