Prescolite CF10UD432EB Manuel d'utilisateur télécharger pdf

InstructionSheet

www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET

101 Corporate Drive• Spartanburg, SC 29303

With representatives of

fices in principal cities throughout North

America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93001021

InstructionSheet

INSTALLATION INSTRUCTIONS

CF10UD226EB/ CF10UD232EB/ CF10UD242EB/

CF10UD426EB/ CF10UD432EB/ CF10UD442EB

WET LOCA

TION RING

MOUNTING SCREWS

Fig. 1

WALL MOUNT

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information

and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,

and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and

during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by

qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.

Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in

compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by

the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from

product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or

the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.

WET LOCATION RING

GASKET

1. Secure mounting plate to wall with box centrally located (Fig.

1). Maximum bolt size is 3/8”. If studs are used, they should

protrude no more than 1/2” beyond wall surface.

2. Hang luminaire on mounting plate and make electrical connec-

tions .

3. Lower luminaire until it rests against wall. Lock it in place by

tightening the two set screws on the bottom of canopy casting.

4. Make electrical connections.

5. Remove the wet location ring (on the top) by unscrewing the 4

screws (Fig. 2).

6. Install the lamps.

7. Mount the wet location ring. Make sure that the gasket stays in

place and it is not damaged. Tighten the screws in order to

provide proper sealing of the luminaire.

”

5”

”

Fig. 2

” Max

InstructionSheet 1

Résumé du contenu

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET101 Corporate Drive• Spartan

Commentaires sur ces manuels

Pas de commentaire

Prescolite CF10UD432EB Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite CF10UD432EB. Prescolite CF10UD432EB User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Prescolite CF10UD432EB