Prescolite SLLED2 Manuel d'utilisateur télécharger pdf

InstructionSheet

701 Millennium Blvd., • Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017297

InstructionSheet

INSTALLATION INSTRUCTIONS

RECESSED LED AISLE LIGHT SLLED2

1. Remove face plate and driver assembly by removing 10-32 tamper resistant screws and place them in bag enclosed.

Be careful not to lose any fasteners.

2. Secure the housing appropriately.

a. For concrete pour and masonry construction refer to Figure 2 and 3.

b. For drywall construction refer to Figure 4, 5, and 6.

3.Connect black fixture wire to black supply wire.

4. Connect white fixture wire to white supply wire and black fixture wire to black supply wire.

5. Secure face plate and driver assembly to housing using tamper proof fasteners removed during step1.

WARNING:

1. DO NOT pinch wires between LED faceplate, driver assembly, and housing. Consult a Qualified

Electrician for all other options that require other wiring configurations.

WARNING:

2. This Product contains chemicals known to the State of California to cause cancer, birth defects and/or other repro-

ductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

FIG. 1

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information

and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,

and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and

during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed

by qualified service personnel. Product must be grounded to avoid potential electric shock or other potential haz-

ard. Product must be mounted in locations and at heights and in a manner consistent with its intended use, and

in compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended

by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from

product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or

the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.

(2) 10-32 TAMPER RESISTANT

SOCKET HEAD CAP SCREWS.

FACE PLATE AND

LED ASSEMBLY

HOUSING

BLACK AND WHITE WIRE

TO BE CONNECTED TO

SUPPLY.

1 2 3

InstructionSheet 1

Résumé du contenu

Page 1 - InstructionSheet

Page 2

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017297InstructionSheet701 Millennium Blvd., • Greenville, SC 29607 With re

Page 3

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017297InstructionSheet701 Millennium Blvd., • Greenville, SC 29607 With re

Commentaires sur ces manuels

Pas de commentaire

Prescolite SLLED2 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Prescolite SLLED2. Prescolite SLLED2 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Prescolite SLLED2